Test your microphone and hear yourself in seconds
A mic test takes ten seconds: press Start, say a few words and watch the level bar move.
Peak:
Everything runs in your browser. Audio is never uploaded. Privacy
Most "nobody can hear me" calls come down to a blocked browser permission or the wrong input device, not a broken microphone. This page shows the input level in dBFS, a waveform or spectrum, and plays back a 5 or 10 second recording so you can hear your own voice.
How to run a mic test
Run a mic test in four steps: allow access, pick the input, speak, then play back your recording.
- Press Start and allow microphone access in the browser prompt.
- If you have more than one microphone, choose the right one in the input list.
- Speak normally. The level bar should move, and the peak marker holds your loudest moment.
- Press Record 5 s or Record 10 s. The clip plays back straight away.
The bar runs from -60 to 0 dBFS. Zero is the ceiling, and anything above it distorts. For speech, peaks around -20 to -6 dBFS are a good target. The page warns you when the signal clips or stays too quiet. Noise suppression and auto gain are off here, so you hear the raw microphone.
When the level bar does not move
If the mic test shows no signal, the cause is almost always permission, the selected input or the system input volume.
| Symptom | Likely cause | What to check |
|---|---|---|
| No signal | Access blocked or wrong input | Click the lock icon next to the address, set Microphone to Allow, reload, pick the device |
| Very quiet | Low input volume or mic too far | Move closer and raise the input volume in system settings |
| Distortion | Peak near 0 dBFS | Lower the input volume until the clipping warning goes away |
Audio stays on your device
The mic test runs entirely in your browser, and nothing you say is uploaded.
The browser asks for permission first and you can revoke it at any time. Level, waveform and spectrum are calculated locally. A 5 or 10 second clip lives only in the open tab. Press Stop or leave the page and the microphone turns off.
FAQ
Why does the mic test show no sound?
Usually the browser blocked the microphone or the wrong input is selected. Allow access and pick your device.
Is my voice saved?
Only if you press Record 5 s or Record 10 s, and the clip stays in your tab.
Can I test a headset microphone?
Yes. Select the headset in the input list, record five seconds and play it back.
More tools
Record yourself in an online voice recorder or measure room noise with the decibel meter. More tools: blabla home.